Bmw Motorrad Front-Wheel; Stand - BMW G 650 GS Sertao Rider's Manual

swinging arm, the brake cal-
8
iper and the rear wheel.
80
Install axle nut 2, but do not
z
tighten it at this point.
Insert the wheel-speed sensor
into the holder and install
screw 1 (with washer, if
applicable).
Adjust the chain sag (
Remove the auxiliary stand.
BMW Motorrad front-
wheel stand
Installing front-wheel

stand

The BMW Motorrad front
wheel stand is not designed
to support the motorcycle
without the assistance of an
auxiliary stand. A motorcycle
resting only on the front wheel
stand and the rear wheel can
topple.
Place the motorcycle on an aux-
iliary stand before lifting the front
wheel with the BMW Motorrad
front-wheel stand.
Place the motorcycle on a suit-
able auxiliary stand.
Use basic stand with tool num-
ber (83 30 0 402 241) in com-
bination with front-wheel ad-
apter (83 30 0 402 242).
74).
Slacken adjusting screws 1.
Push the two adapters 2 apart
until the front forks fit between
them. Adjust the adapter studs
to suit the front suspension.
Use locating pins 3 to set the
front-wheel stand to the de-
sired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.