Mounting (Rack) - Tripp Lite SmartPro SMX2200XLRT2U Owner's Manual

Mounting (Rack)

Mount your equipment in either a 4-post or 2-post rack or rack enclosure. The user
must determine the fitness of hardware and procedures before mounting. If hardware
and procedures are not suitable for your application, contact the manufacturer of your
rack or rack enclosure. The procedures described in this manual are for common rack
and rack enclosure types and may not be appropriate for all applications.
4-Post Mounting
All UPS models include hardware required to mount in a 4-post rack. Select models
include an adjustable rack-mount shelf kit to provide additional support. If your UPS
model does not include an adjustable rack-mount shelf kit, skip steps 1 and 2.
Connect the two segments of each shelf
1
using the included screws and nuts
Leave the screws slightly loose so that the
shelves can be adjusted in the next step.
Adjust each shelf to fit your rack, then mount
2
them in the lowest available space of your
rack with the screws, nuts and washers
provided
C
should face inward. Tighten the screws that
connect the shelf segments
Attach mounting ears
3
holes of your equipment
provided
F
Using an assistant if necessary, lift your
4
equipment and slide it onto the mounting
shelves. Attach your equipment to the rack
by using the appropriate hardware
its mounting ears and into the rack rails.
. Note that the support ledges
to the front mounting
D
using the screws
E
. The ears should face forward.
A
.
B
.
B
through
G
4
B
A
1
C
2
E
D
3
G
4
B
F