Maintenance - ECM Mechanika V Slim User Manual

Caution!
Beware of hot sprayings while cleaning the group.
If you clean the brew group to often with cleaner, it may start squeaking. Don´t clean it to
often with cleaner, you will degrease all the moving parts and they will wear out quickly. It´s
better if you clean the brew group from time to time without cleaner.
Empty the water drip tray regularly and do not wait until it is full in case the machine is not directly hooked up
to a water drainage.

7.3 Maintenance

Vorsicht!
Make sure that the machine is disconnected from the power supply during maintenance and
when replacing parts.
(If you have any questions, please contact your specialised dealer.)
Replacing the group gasket and the shower screen (Group gasket and shower screen must be changed at
the same time)
Switch off the machine (power switch in position"0") and disconnect the power cord.
1
2 Let the machine cool down to room temperature.
Follow the steps as indicated below:
1
Brew group in the beginning.
4
Remove the shower screen and
the gasket completely.
Translation of the German original user manual
2
Use a flat screwdriver to pry out
the shower screen and the group
gasket.
5
Keep the new spare parts ready
at hand (the rounded side of the
group gasket with ECM print
faced upwards to the brewing
group).
3
The shower screen and the
gasket are now nearly removed.
6
Clean the group with a brush.
Lock the shower screen firmly
into the gasket.
ENGLISH
22