Technical Specifications - Bosch AVENAR Series Installation Manual

AVENAR panel series
Fixing the Ethernet cables to the panel controller
The housing in which the panel controller is installed must be
open.
Lift and swing out the panel controller if already mounted.
1.
2.
3.
P
Fixing the Ethernet cables to the housing
The housing in which the panel controller is installed must be
open.
Lift and swing out the panel controller if already mounted.
1.
2.
3.
P
5

Technical Specifications

Electrical
Current consumption (mA at
24 VDC)
Maximum power loss (W)
Bosch Sicherheitssysteme GmbH
Look at the back of the device.
Use cable ties to attach the Ethernet cables to the fixing
points as shown in the figure (see 09, page 12 ).
Check the routing of the cables. They must not be crushed
or trapped.
The cables are fixed to the panel controller.
Look at the top area of the housing.
Use cable ties to attach the Ethernet cables to the fixing
points as shown in the figure (see 10, page 13 ).
Check the routing of the cables. They must not be crushed
or trapped.
The cables are fixed to the housing.
Technical Specifications | en
– standby: 170
– alarm: 400
10
2020.05 | 6.0 | F.01U.347.557
39