Table of Contents
Advertisement
8800 Series Chassis Switch Hardware Installation Guide
Verify that the EMI gasket is on the top of the panel and the stenciled part number is right
side up.
Figure 38. Blank front panels in an 8800 Series Chassis
Use a #2 Phillips screwdriver to tighten the captive screws at each end of the blank front
3.
panel.
Tighten the screws of each installed blank front panel before inserting additional
•
modules or blank front panels. Otherwise, you might unseat modules or blank front
panels that you have not secured.
Leave the ESD-preventive wrist strap permanently connected to the chassis so that it
•
is always available when you need to touch ESD-sensitive components.
Remove a Blank Front Panel
To remove a blank front panel:
Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to
1.
the ground receptacle at the top left corner of the switch front panel.
Chapter 7. Install Modules and Establish Initial Management Access
| 69
Advertisement
Table of Contents
