Ryobi RLT-710 Owner's Operating Manual page 9

4. Insert in the auxiliary handle fixing bolt and tighten clockwise by hand (Fig. 7, 8)
5. Adjust the auxiliary handle to required position (Fig. 9, 10, 11)
Fig. 9
6. Tighten the auxiliary handle fixing bolt clockwise and clamp the auxiliary handle locking lever in upper posi-
tion to fix the auxiliary handle in place (Fig. 12, 13).
Fig. 12
note: the tooth system must interlock.
note: only tighten the quick release bolt so that it is possible to clamp the lever down with light
pressure. if the lever cannot be clamped, slightly loosen the bolt. if the lever can be clamped without
resistance, tighten the bolt.
AdJUstinG LenGtH (Fig. 14)
Adjust the length to suit your height. It is recommended to use the product with the pole fully extended.
1. Loosen the locking sleeve for length adjustment (5) in anticlockwise direction.
2. Pull the telescopic tube (6) to desired length.
3. Tighten the locking sleeve in clockwise direction.
Fig. 14
5
1
2
3
6
prepArAtion
Fig. 10
Fig. 13
8
Fig. 11