Operating Instructions; General Glass Information; Louvre Removal; Glass Cleaning - Irving IRHEDV32 Installation Instructions & Homeowner's Manual

GENERAL GLASS INFORMATION

Only ceramic glass approved by Vermont
Castings Majestic Products Company may
be used for replacement on this unit.
1. The use of substitute glass will void all product
warranties.
2. Care must be taken to avoid breakage of the glass.
3. Under no circumstances should this appliance be
operated without glass properly installed, or with any
cracked or broken glass. Replacement of any glass
assembly as supplied by the manufacturer should be
done by a licenced qualified service person.

LOUVRE REMOVAL

To remove louvre pull louvre up and then lift out.
1. Lift Up
2. Lift Out

GLASS CLEANING

It will be necessary to clean the glass periodically. During
start-up condensation, which is normal, forms on the
inside of the glass and causes lint, dust and other airborne
particles cling to the glass surface. Also initial paint curing
may deposit a slight film on the glass. It is therefore
recommended that the glass be cleaned two or three times
with a non-ammonia household cleaner and warm water
(we recommend gas fireplace glass cleaner). After that the
glass should be cleaned two or three times during each
heating season depending on the circumstances present.
Clean glass after first two weeks of
operation.

GLASS FRAME REMOVAL

1. Remove four (4) bottom fastening nuts with a 3/8" nut
driver. Fig. 15.
2. Lift up and unhook glass frame at the top.
10/24 NUT
10/24 NUT
10003929

OPERATING INSTRUCTIONS

GLASS
FRAME
10/24 NUT
W
10/24 NUT
1 . Remove front glass. (See "Glass Removal" section)
2. Remove logs from packaging.
3. Place rear log (KR4) on rear bracket (ensure log is
seated properly, leveled and centered to the unit), so it
will not move from side to side and it is firmly positioned
on the bracket.
4. Slip front ember log (KR1) down in the front deflector.
5. Place front left log (KR2) on top burner, left side. Use
log's bottom holes to locate it into the left bracket log
locator studs.
6. Place front right log (KR3) on top of burner, right side.
Use log's bottom holes to locate it into the right bracket
log locator studs.
7. Place burner lava rocks material on top of burner. (See
Fig. 16 for proper location).
8. Place top right log (KR6) onto locator notches. Ensure
log is secure.
9. Place top left log (KR5) onto locator notches. Ensure
log is secure.
Fig. 14
IRHEDV32
Fig. 15
INSTALLATION OF LOGS
& BURNER LAVA ROCK
Top logs must be placed properly into
notches.
V
Fig. 18
9