Trim Options; A) A-Trim Options For Irhedv32; A1 - Rhess/Rhesl/Rhessd/Rhesld & Rhesxl Trims - Irving IRHEDV32 Installation Instructions & Homeowner's Manual

A-TRIM OPTIONS FOR RHEDV32
IMPORTANT: Only Trim Panel Assemblies approved by Vermont Castings Majestic Products Company can be used.
A1) RHESS, RHESL, RHESSD, RHESLD & RHESXL TRIMS
FRAME ASSEMBLY
RHESS, RHESL, RHESSD, RHESLD and RHESXL
1. Lay Trim Top Facing and Trim Side Facings, face down
on to an even surface such as a table or floor. Be sure
not to scratch the painted surfaces.
2. Install the nuts and bolts (Fig. 21).
FRAME TOP
LEFT
FRAME
FIG.1
AS SHOWN FROM BACK
TRIM ASSEMBLY
RHESS, RHESL, and RHESXL (Fig. 22)
1. Install trim channels (left and right sides). Use two
screws to assemble each piece.
2. Slide on the trim top channel and fasten it from the back
side.
3. Install the trim top deflector and use two screws to fasten
it. (Fig. 22 & 23)
4. Remove ALL plastic protective covering from brass trim.
SCREW
TRIM SIDE
CHANNEL
AS SHOWN FROM FRONT
10003929
10/24
SCREWS
RIGHT
FRAME
10/24
NUTS
Fig. 21
TRIM TOP CHANNEL
TRIM SIDE
CHANNEL
DEFLECTOR
TRIM TOP
Fig. 22
Trim Top Deflector
Side View
RHESSD and RHESLD (Fig. 24)
1. Install trim channels (left and right sides). Use two
screws to assemble each piece.
2. Peel off plastic protective covering from top edges of
the inner sides where they will be covered by the inner
top trim facing.
3. Place the trim facing inner top in place (do not fasten it
yet). Peel off the plastic protective covering from the
bottom edge.
4. Install the trim top deflector and fasten it (will hold the
inner top piece). Use two screws to assemble them.
5. Install trim channels (left and right sides). Use two
screws to assemble each piece.
6. Slide on the trim top channel and fasten it from the back
side.
7. Remove ALL plastic protective covering from brass
trim.
SCREW
TRIM SIDE
CHANNEL
TRIM FRAMING
AS SHOWN FROM FRONT
A flat louvre kit OR a bay window kit
needs to be chosen to complete the
installation.
Trim Frame Top Section
Fig. 24
TRIM TOP CHANNEL
TRIM FRAMING
INNER TOP
TRIM SIDE
DEFLECTOR
CHANNEL
TRIM TOP
INNER SIDES
Fig. 24
17