Operating Tips; Maintenance; Maintenance Schedule; Storage - Ariens Gravely IKON-X Operator's Manual

WARNING: Blades rotate
when impeller rotates. Impeller
rotates when blades rotate.
Block blades to prevent
rotation before proceeding.
6. Clear grass from blower assembly.
7. Reinstall hose and tighten hose clamp.

OPERATING TIPS

IMPORTANT: Do not remove more that 3.2
cm (1 1/4") of grass when bagging.
• Cut grass when it is dry.
• Cut grass in two passes when cutting thick,
long, or wet grass. Make the first cut higher
than desired. Make the second cut at
desired height.
• Always use full throttle when bagging.
• Adjust ground speed as necessary to allow
the bagger to pick up clippings.

MAINTENANCE

WARNING: AVOID INJURY.
Read and understand the
entire Safety section before
proceeding.
Your Ariens dealer can provide service and
adjustments to keep your unit operating at
peak efficiency.
Contact an authorized engine manufacturer's
service center for engine service.

MAINTENANCE SCHEDULE

Service Performed
Check Front Weight
Check Hose
Check Mesh Bags
Check Fasteners
Inspect Bagger Parts
Clean Unit
Check V-Belt
Replace V-Belt
1. Remove belt cover.
2. Release belt tensioner.
3. Remove belt from spindle pulley and
4. Install new V-belt. See Install Drive Belt
5. Reinstall belt cover.
IMPORTANT: NEVER spray unit with high-
pressure water. DO NOT store unit outdoors.
• Clean plastic surfaces with sponge and
• Remove all debris from hopper before
• Remove all dirt, grease, leaves, etc. from
• Store in a clean, dry area.
• Ensure all fasteners are properly tightened.
• Touch up all rusted or chipped painted
•
•
•
•
•
•
•
EN - 20
blower assembly.
on page 13.

STORAGE

WARNING: AVOID INJURY.
Read and understand the
entire Safety section before
proceeding.
mild detergent. Dry with a soft cloth.
storing.
unit.
Inspect moving parts and belts for damage
and wear.
surfaces.