Installation - Ariens Gravely IKON-X Operator's Manual

5. All Decks Except 60": Remove three 1/4"
tapping screws retaining belt cover and
remove belt cover. Retain all parts for
operation without bagger. See Figure 5.
6. 60" Decks Only: Remove three 3/8"
center locking flange nuts retaining belt
cover and remove belt cover. Retain all
parts for operation without bagger. See
Figure 6.
Figure 5
Figure 6
Remove Mower Blades
(Model 815049)
CAUTION: Rotating one blade
will cause all blades to rotate.
Mower blades are sharp. Use
heavy gloves or cover blades
with tape.
1. Remove and retain hex nuts and
Belleville washers retaining mower
blades. Note orientation of washers for
installation. Retain blades for operation
without bagger. See Figure 7.

INSTALLATION

Install Mower Blades
(Model 815049)
CAUTION: Rotating one blade
will cause all blades to rotate.
Mower blades are sharp. Use
heavy gloves or cover blades
with tape.
See Figure 8.
1. Install three 25-degree blades (item 18)
using hardware removed earlier. Ensure
concave side of washer faces mower
blade.
2. Using a sturdy block of wood or other
suitable device, block blades from turning
and torque nuts to 136 N•m – 163 N•m
(100 lb-ft – 120 lb-ft).
EN - 10
Figure 7