Vermont Castings 2310 Homeowner's Installation And Operating Instructions Manual page 10

Vermont Castings Vigilant
Single-wall
connector
(457 mm)
No heat shields
Single-wall connector
Top exit
Rear and chimney
(457 mm)
connector heat
shields
1
Single-wall connector
Rear exit,
(457 mm)
Rear heat shield
Double-wall connector
Top exit
(394 mm)
Rear heat shield
Single-wall connector
No connector heat
shields
Single-wall connector
Connector heat
shields installed
Double-wall
connector
1. A ceiling heat shield, 24" (610 mm) in diameter and suspended 1" (25 mm) from the ceiling, must surround the chimney con-
nector in installations in which the chimney connector penetrates the ceiling. The chimney connector shield extends only to
24" (610 mm) above the flue colllar.
2. The ceiling heat shield required when the chimney connector shields are used should meet the wall protector. This will require
trimming the ceiling shield along the line of intersection with the wall protector.
10
Vigilant II Clearance Chart
Unprotected Surfaces
Stove Installed Par-
allel to Wall
Side Rear
20"
18"
(508 mm)
18" 13"
(330 mm)
18" 13"
(330 mm)
13"
15¹⁄₂"
(330 mm)
Chimney Connector Clearance
All Installations
17" (432 mm)
11" (279 mm)
12" (305 mm)
Clearance to Combustibles in Front of Stove
Stove Clearance
Stove Installed Par-
Stove in Corner
Corners Side
16" 7"
(406 mm) (178 mm)
16" 7"
(406 mm) (178 mm)
N/A
(178 mm)
16"
(457 mm) (178 mm)
All Installations
48" (1219 mm)
Protected Surfaces
Stove in Corner
allel to Wall
Rear
13"
(330 mm)
11"
(279 mm)
11"
7"
(279 mm)
7"
10¹⁄₂"
(267 mm)
All Installations
9" (229 mm)
9" (229 mm)
7" (178 mm)
Corners
9"
(229 mm)
9"
(229 mm)
N/A
9"
(229 mm)
2
2000898