Table of Contents
Advertisement
4. Remove both air shutters from burner pan by remov-
ing shutter retaining screw then air shutter. (Fig. 26)
5. Install air shutters supplied in kit on burner pan.
Replace shutter retaining screw. For conversion to
Natural Gas adjust new air shutters so slots are cov-
ered. For conversion to Propane Gas, adjust new air
shutters so slots are open. NOTE: NV360 air shutter
has only one hole, closed. Secure shutter retaining
screws. (Fig. 27)
6. Re-install manifold to burner pan.
Burner Pan
Shutter
Retaining
Screw
Air Shutter
Fig. 26 Remove air shutter from burner pan.
CO103
Gas Conversion
Air shutter
Shutter Retaining
2/15/99 djt
Screw
Natural Gas
Slots Covered
Shutter
Retaining
Screw
One (1) Hole Closed
Slots Open
Front View
Fig. 27 Install conversion air shutters.
NOTE: It is not necessary to remove the pilot tube for
conversion.
7. Remove pilot hood by lifting up. (Fig. 28)
8. Remove pilot orifice with Allen wrench. (Fig. 29)
9. Install LP pilot orifice.
10. Re-install pilot hood and be sure to align with index
tab. Installation complete.
20003565
CO103
Burner
Pan
Front View
Top View
Burner
Pan
NV360
Holes Open
Burner
Holes Open
Pan
NV580
Holes Open
CO110
CO109
air shutter conversion
6/22/01 djt
Pilot
Hood
Pilot
Bracket
Fig. 28 Remove pilot hood.
Index Tab
Snap Ring
Fig. 29 Remove pilot orifice.
Replacement of Ceramic Hearth Panels
CO106a
DV360/580
1. Turn unit OFF. NOTE: Be sure unit is cool.
Gas Conversion
2. Remove glass.
Pilot2
1/28/00 djt
3. Remove logs. Remove old hearth panels and dis-
card.
4. Remove two (2) screws securing grate to hearth
pan. (Fig. 30)
5. Set left and right panels on hearth and bring towards
front of unit.
6. Replace assembly.
7. Replace logs.
8. Re-install glass panels.
Screw
Hearth Panels
Front of Unit
Fig. 30 Hearth panel location.
H100a
hearth Panels
1/27/00 djt
NV360/580 Series
CO105a
Allen Wrench
CO105a
DV360/580
Gas Conversion
Pilot
1/28/00 djt
CO106a
Screw
Burner
Grate
H100a
19
Hide quick links:
Advertisement
Table of Contents
