Log Installation; Ember Material Placement; Lava Rock; Optional Thermal Vent Damper - Majestic fireplaces NVCR36R Series Installation And Homeowner’s Operating Manual

Log Installation

1. Open glass door (if installed).
2. Remove logs from the packaging. (As with all plastic,
these bags are not toys and should always be kept
away from children and infants.)
3. Place rear log on back bracket. Ensure that log is
firmly positioned and there is no side-to-side move-
ment.
4. Place front log on front burner (starting toward the
rear of the front burner) and slide it forward until the
notches lock into place.
5. Place the top logs onto the locator notches. Ensure
the logs are secure.
6. Place end log on open end side of unit. (Fig. 10)

Ember Material Placement

Separate the ember material into smaller pieces, rough-
ly 1/2" diameter and place on bracket over front burner
tube. Do not pack down; leave in loose, fluffy condition
for most realistic ember effect. (Fig 11)
f i r e - p a r t s . c o m

Lava Rock

The lava rock provided with this fireplace must be
placed on the firebox base on either side of the burner
assembly. Do not place lava rock in combustion pan.
Under no circumstances should lava rock
be placed on any part of the burner assem-
bly.
Right Crossover Log
Left Crossover Log
Rear Log
Front
Log
FP801
Fig. 10 NVCR36R/L log placement. (Right Shown)
Overhead View
FP802
Fig. 11 Ember placement.
FP802
NVCR
20001315
Ember placement
5/3/99 djt
End Log
FP801
NVCR Logs
5/3/99 djt
1/2" Diameter
Majestic Fireplaces
Optional Thermal Vent Damper - TVD6/7
Attach the thermal vent damper to the combustion
dome with two (2) screws. Be sure the tab points down.
(Fig. 12)
Start the appliance and operate it for approximately
five (5) minutes. Turn the unit off and check if the vent
damper is in the open position (blades down from hori-
zontal position). If the damper has not opened, check
installation.
NOTE: Not for use in Canada.
Tab
Thermal
Vent Damper
Screws
Fig. 12 Attach the thermal vent damper.
FP577
NVB—TVD6/7

Finishing

11/17/97
CAUTION: All joints between the finished
wall and the appliance surround (top and
sides) may be sealed only with noncom-
bustible material. Only noncombustible
material can be applied as facing to the ap-
pliance surround (the black painted face).
Finish the wall with the material of your choice. Refer to
Figures 13 and 14 for specific clearances when install-
ing a combustible mantel or other combustible projec-
tion.

Hearth Extension

A hearth extension in front of appliance is recommend-
ed but not required.
NVCR Series B-Vent
©
FP577
11