Assembling The Light Kit - Hunter Hardwick 50593 Installation Manual

1
Partially install two light kit screws, found in the
hardware bag, halfway into the motor housing as shown.
It does not matter which two screw holes you choose.
3
Connect the single-pin connectors from the light kit to the
connectors from the fan. Connect the white wires together.
Connect the blue and black wires together. Lift the light kit
until its screw holes are aligned with the screw holes in the
upper switch housing. Make sure all the wires from the light
kit are snug inside the center of the light kit, not pinched in
between the upper switch housing and the light kit or hanging
out of the sides.
Note:
Fan style may vary.
Ceiling Bracket Downrod

Assembling the LIght Kit

2 of 6
Light Kit Screw
bag
4
Install the three switch housing screws, found in
the
Installing the Bulbs
Hanging Fan Wiring
2
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Wrap the keyhole slots around the
screws and twist counterclockwise. Install the
third light kit screw. Tighten all screws securely.
bag
hardware bag. Tighten all three screws.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Canopy Blades
1 of 6
Light Kit Screw
bag
3 of 6
Light Kit Screw
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Light Control
1886
8