Installation; Connection - JVC KD-SR83BT Instruction Manual

Wiring connection
IMPORTANT
We recommend installing the unit with a
commercially available custom wiring harness
specific for your car and leave this job to
professionals for your safety. Consult your car
audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
remote control adapter
Blue: To power
Custom wiring
antenna
harness
(separately
Blue/white:
purchased)
To amplifier
Brown (not used)
Recommended connection
Front output/3-way crossover: Mid
Range output
Rear/subwoofer output/3-way
crossover: Woofer output
Antenna terminal
Light blue/yellow
To the steering wheel
Join the same color wires together.
Blue/white: Remote (12 V
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker/3-way crossover: Mid range
speaker (right)
Gray/black
White: Front speaker/3-way crossover: Mid range
speaker (left)
White/black
Purple: Rear speaker/3-way crossover: Tweeter
(right)
Purple/black
Green: Rear speaker * 2
/3-way crossover: Tweeter
(left)
Green/black * 2
Signal cord (not supplied)
Microphone input jack ( 11)
Fuse (10 A)
Remote wire (not supplied)
350 mA)
Separate red wire
Make this connection if your vehicle factory
wiring harness does not have "12 V ignition
switch" wire.
* 1
Firmly connect the ground wire of the
amplifier to the car's chassis to avoid
damaging the unit.
* 2
You can also connect a subwoofer speaker
directly using this lead without an external
subwoofer amplifier. For setting,
Part list for

installation

JVC Amplifier * 1
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
Ignition switch
(D) Wiring harness
Car fuse block
(E) Extraction key
21.
31
ENGLISH