Generac Power Systems PWRcell X7600 Series Installation Manual page 31

4. See Figure 6-25. Use the up and down arrows to
highlight Enable Ethernet then press the center
button.
Figure 6-25. Ethernet Configuration (2 of 4)
NOTE: Select IP Settings for advanced settings.
5. See Figure 6-26. Press the right arrow to highlight
Confirm then press the center button.
Figure 6-26. Ethernet Configuration (3 of 4)
6. Verify the control panel Internet LED is lit indicating
a valid Internet connection.
NOTE: If the Internet LED is not lit, see
bleshooting.
7. The Generac PWRcell system is now Ethernet-
enabled and can send and receive data.
8. Log onto https://register.generac.com/
and register the REbus devices.
NOTE: See Figure 6-27. The Ethernet screen on Gen-
erac PWRcell's Inverter LCD displays IP address, MAC
address and connection status.
Figure 6-27. Ethernet Configuration (4 of 4)
Installation Manual for Generac PWRCell Inverter
Manually Configuring IP Settings
NOTE: On networks not configured for DHCP, use the
MAC address to locate the device on the network.
To manually configure settings:
1. See
010046
2. See
010047
Ethernet Trou-
3. Adjust any of the following:
•
•
•
to sign up
•
NOTE: Contact your network system administrator to
connect the Generac PWRcell Inverter to a restricted net-
work.
009981
Commissioning and Setup
Figure 6-28. Press the center button from the
Ethernet settings screen and select IP Settings.
Figure 6-28. Ethernet Configuration (1 of 2)
Figure 6-29. From the IP Settings menu select
Manual.
Figure 6-29. Ethernet Configuration (2 of 2)
IP
Subnet Mask
DNS
Gateway
010048
010049
27