Generac Power Systems PWRcell X7600 Series Installation Manual page 28

Commissioning and Setup
5. Use the up and down arrows to highlight TOU
Schedule and press the center button to select.
6. Use the up and down arrows to adjust the TOU
Schedule. Once the desired value is set, press the
center button to exit edit mode.
NOTE: See the latest Time of Use Program Guide for
current TOU schedule values. The program guide is
available at www.generac.com.
7. Set the Time Zone to the desired location based on
Table 1: Time Zone
value is set, press the center button to exit edit
mode.
Table 1 - Time Zone Codes
Time Zone
UTC
US/Eastern
US/Central
US/Mountain
US/Pacific
US/Alaska
US/Hawaii
8. See Figure 6-13. To commit changes to all entries,
highlight Commit. Press the center button, then
use the arrows and center button to confirm the
choice.
Figure 6-13. Configuring TOU Schedule (4 of 4)
See Figure 6-14 and Figure
LCD will alternate between a TOU Scheduler Running
Screen and a Current Operational Mode screen. Both
screens will display the time until the next system change
and the mode the system will change to. The TOU
Schedule name will be listed at the bottom of the device
page.
See Figure 6-16 and Figure
the text above the power flow diagram will alternate
between Scheduler Active and the current operational
mode.
24
Codes. Once the desired
Units
0
1
2
3
4
5
6
010112
6-15. When enabled, the
6-17. On the home page,
Figure 6-14. Running
Figure 6-15. Current Operational Mode
Figure 6-16. Scheduler Active
Figure 6-17. Current Mode
Installation Manual for Generac PWRCell Inverter
010113
010115
010116