Stihl MS 194 T Instruction Manual page 8

English
THE CHAIN SAW
For illustrations and definitions of the
chain saw parts see the chapter on
"Main Parts."
WARNING
Never modify this chain saw in any way.
Only attachments supplied by STIHL or
expressly approved by STIHL for use
with the specific STIHL model are
authorized. Although certain
unauthorized attachments are useable
with STIHL chain saws, their use may, in
fact, be extremely dangerous.
WARNING
Never operate your chain saw if it is
damaged, improperly adjusted or
maintained, or not completely and
securely assembled.
If this chain saw is subjected to
unusually high loads for which it was not
designed (e.g. heavy impact or a fall),
always check that it is in good condition
before continuing work. Check in
particular that the fuel system is tight (no
leaks) and that the controls and safety
devices are working properly. Do not
continue operating this chain saw if it is
damaged. In case of doubt, have it
checked by your STIHL servicing dealer.
6
THE USE OF THE CHAIN SAW
Transporting the Chain Saw
WARNING
Always stop the engine before putting
the chain saw down. Carrying a chain
saw with the engine running may be
extremely dangerous.
Accidental acceleration of the engine
can cause the saw chain to rotate.
Always engage the chain brake when
taking more than a few steps.
By hand: When transporting your chain
saw by hand, the engine must be shut
off and the chain saw must be in the
proper position, i.e., grip the top handle
and place the muffler away from the
body; the chain guard (scabbard) should
be over the saw chain and guide bar,
which should point backwards, away
from the direction in which you are
walking.
By vehicle: When transporting in a
vehicle, keep saw chain and bar covered
with the chain guard (scabbard).
Properly secure your chain saw to
prevent turnover, fuel spillage and
damage to the chain saw.
Fuel
Your STIHL chain saw uses an oil-
gasoline mixture for fuel (see the "Fuel"
chapter in this instruction manual).
WARNING
Gasoline is an extremely
flammable fuel. If spilled
and ignited by a spark or
other ignition source, it
can cause fire and seri-
ous burn injury or
property damage. Use
extreme caution when
handling gasoline or fuel
mix. Do not smoke or
bring any fire or flame
near the fuel or the chain
saw. Note that combus-
tible fuel vapor may
escape from the fuel
system.
Fueling Instructions
WARNING
Pick a Safe Location
To reduce the risk of fire and explosion,
fuel your chain saw in a well-ventillated
area, outdoors away from flames, pilot
lights, heaters, electric motors, and
other sources of ignition. Vapors can be
ignited by a spark or flame many feet
away. Select bare ground for fueling
and move at least 10 feet (3 m) from the
fueling spot before starting the engine.
MS 194 T