Table of Contents
Advertisement
3
OTHER FUNCTIONS
Using the Message function
The transceiver can receive and send short
messages.
Receiving
When receiving, a received message's header and the
Talkgroup name are displayed.
Push [RX MSG] to display a received message.
HELLO!
TALKGROUP01
Last Call
Transmitting
CAUTION: DO NOT transmit without an antenna.
1. Rotate TALKGROUP SELECTOR to select a
talkgroup.
2. Push [S1] to open the "Message List".
You can also assign [P1] key as a shortcut to the
"Message List" (p. 8).
3. Select a message to send.
TIP: Writing a new message
1. Select a blank on the "Message List" screen,
and then push [OK].
• The "Message Display" screen is displayed.
2. Push [OK] again to display the cursor.
3. Enter a message of up to 100 characters.
Message Display
abcde
To enter a character, push [Up] or [Down].
Usable characters: a ~ z, A ~ Z, 0 ~ 9,
To move the cursor, push [Right] or [Left].
To insert a space, push [P1].
To delete, push [P2] or [BACK].
4. Push [PTT] to send the message.
Received message list
You can read received messages on the "Received
Message" screen.
[OK] > PTT Options > Received Message
You can also read received messages to push [P2].
00:00
RX MSG
Using the Emergency mode
In the Emergency mode, the transceiver can transmit
an Emergency call, as shown below.
satellite.
1. Hold down [EMER] for 2 seconds.
• Beep sounds, and the transceiver enters the
Emergency mode.
"REQUESTING" is displayed while the transceiver
requests the transmission.
2. When "TALKING" is displayed, the transceiver
transmits the mic audio for 5 seconds.
Using the Key Lock function
You can use the Key Lock function to prevent
accidental or unnecessary function access.
1. Assign the function to the [P2] key in the Menu
screen.
[OK] > Functions > Key Setup > P2 Key
2. Push [P2] until "Lock ON" or "Lock OFF" is
displayed to turn the function ON or OFF.
• "
" is displayed while the function is ON.
Auto Key Lock function
pushed for 30 seconds.
selector.
Turn the function ON or OFF in the Menu screen.
[OK] > Functions > Auto Key Lock
• "
" is displayed while the function is ON.
Push [P2] until "Lock OFF" is displayed to turn OFF
the function.
4
Advertisement
Table of Contents
