Indicator Lights - Siemens WP13T483BY Instruction Manual

Table of Contents

Advertisement

Troubleshooting minor faults
In this chapter, we will explain to you how you yourself may easily remedy small problems.
Malfunctions of the washing machine are indicated on the display panel.
Flashing
indicator
Cause / Remedial action
No water is supplied: the tap is not open.
• Some time after the start of the programme:
• If you have selected DELAYED START OR DELAYED END, the allocated
• Remedial actions:
• This malfunction may also be caused by a defective connection of the
• Remedial actions: Replace Aquastop hose (only if Aquastop model).
Pump filter blocked. Clean the pump filter (see chapter entitled CLEANING
THE FILTER) and restart the programme using the "Start/Pause"
pushbutton.
Check drain hose: The connection must not be blocked (see chapter
entitled CONNECTIONS - WATER DRAINAGE).
Door safety: Lid improperly closed.
• After the Start of a programme or after a Pause:
• If you have selected DELAYED START OR DELAYED END, the allocated
• Remedial actions:
Drum blocked. Check if a small laundry item (e.g. handkerchief, sock...) has
gotten between the detergent dispenser and drum. For access to the
bottom of the dispenser, refer to the chapter entitled CLEANING THE
FILTER.
- The programme does not continue,
- the warning signal and message d01 flash ,
- a continuous beeping sound is heard.
time until the programme starts counts down. A short time later, the same
signals and displays as shown above are issued.
- Open the tap ,
- Press the "Start/Pause" pushbutton .
- The programme restarts.
water inlet hose (see chapter entitled CONNECTIONS - WATER
DRAINAGE). If you have a Aquastop model, check if Aquastop hose
safety functions on water connection have come loose - window red.
- the programme does not continue,
- the warning signal and message d07 flash,
- a continuous beeping sound is heard.
time until the programme starts counts down. A short time later, the
same signals and displays as shown above are issued.
- Close the lid on the washing machine.
- Press the "Start/Pause" pushbutton.
- The programme starts.
27

Advertisement

Table of Contents
loading

Table of Contents