Coil Cable Assembly; Inserting Batteries - Minelab X-TERRA Series Instruction Manual

5

Coil Cable Assembly

Wind the coil cable around the lower
and middle shaft enough times to take
up the slack.
Use the velcro tabs to hold the coil cable in
place against the shaft.
Align the coil plug and push it into
the socket in the back of the control box,
firmly tightening the retaining ring to hold it
in place.

Inserting Batteries

The X-TERRA requires 4 × AA batteries.
Access the battery compartment via the
battery door located on the side of the
control box.
Place batteries into the compartment,
ensuring the positive (+) and negative (–)
contacts match the diagram.
Close the battery door by pushing and
sliding it downwards.