Inspecting Burner; To Turn Off Gas To Appliance; Manual Lighting Procedure - Vanguard VGP30B Owner's Operation And Installation Manual

Vent-free propane gas heater
Table of Contents

Advertisement

OPERATING
HEATER
Continued
INSPECTING
BURNER
100100

TO TURN OFF GAS TO APPLIANCE

Shutting Off Heater
1. Turn control knob clockwise
2. Press in control knob and turn clockwise
3. Turn off all electric power to the appliance if service is to be performed.
Shutting Off Burner Only (pilot stays lit)
1. Turn control knob clockwise

MANUAL LIGHTING PROCEDURE

1. Remove front panel (see Figure 6, page 11).
2. Follow steps 1 through 5 under Lighting Instructions, pages 17 and 18.
3. With control knob pressed in, strike match. Hold match to pilot until pilot
lights.
4. Keep control knob pressed in for 30 seconds after lighting pilot. After 30
seconds, release control knob.
5. Replace front panel.
Check pilot flame pattern and burner flame pattern often.
PILOT FLAME PATTERN
Figure 18 shows a correct pilot flame pattern. Figure 19 shows an incorrect pilot
flame pattern. The incorrect pilot flame is not touching the thermocouple. This will
cause the thermocouple to cool. When the thermocouple cools, the heater will shut
down.
Thermocouple
Figure 18 - Correct Pilot Flame Pattern
Thermocouple
Figure 19 - Incorrect Pilot Flame Pattern
to the PILOT position.
Clockwise
Clockwise
to the PILOT position.
Clockwise
GOOD PILOT/LP
BAD PILOT/LP
to the OFF position.
Pilot Burner
GRH/OV 007
Pilot Burner
GRH/OV 008
Continued
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vp2000bb

Table of Contents