Table of Contents
Advertisement
P/N 3003960_A
MERCHANDISER ELECTRICAL DATA
Refer to Appendix A of this manual or the
merchandiser's serial plate for electrical
information.
FIELD WIRING
Field wiring must be sized for component
amperes stamped on the serial plate. Actual
ampere draw may be less than specified.
ALWAYS CHECK THE SERIAL PLATE FOR
COMPONENT AMPERES
POWER SWITCH
The main electrical power switch is located
behind the front louvered access panel. The
power switch must be turned OFF before
servicing the merchandiser.
ELECTRICAL CONNECTIONS
All wiring must be in compliance with NEC
and local codes. GSVM 4060F is provided
with a power cord.
— LOCK OUT / TAG OUT —
To avoid serious injury or death from electri-
cal shock, always disconnect the electrical
power at the main disconnect when servicing
or replacing any electrical component. This
includes, but is not limited to, such items as
doors, lights, fans, heaters, and thermostats.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
ELECTRICAL / REFRIGERATION
ELECTRICAL OUTLET:
Before the merchandiser is connected to any
wall circuit, use a voltmeter to check that the
outlet is at 100% of the rated voltage. The wall
circuit must be dedicated for the merchandiser.
Failure to do so voids the warranty. Do not
use an extension cord. Never plug in more
than one merchandiser per electrical circuit.
• Always use a dedicated circuit with the
amperage stated on the unit.
• Plug into an outlet designed for the plug.
• Do not overload the circuit
• Do not use long or thin extension cords.
Never use adapters.
• If in doubt, call an electrician.
GSVM 4060F has a
factory-installed power
cord that is attached at
the electrical box.
NEMA 5-20R
Risk of Electric Shock. If cord or plug
becomes damaged, replace only with
a cord and plug of the same type.
Merchandiser must be grounded.
Do not remove the power supply cord ground.
GSVM 4060F Merchandisers
2-1
Advertisement
Table of Contents
