Universal Remote Control UR-J550TVE Operating Manual

Operating Manual
for 2 in 1 Cable TV

Remote Control

UR-J550TVE
Universal Remote Control, Inc.
www.universalremote.com
OEE-0017D Rev 03(05/14/02)
Instructions
This remote control is preprogrammed
to operate CABLE Box.
Please program it for your TV by
following the instructions shown below.
Batteries
The remote control uses AAA batteries.
Please be sure to match the batteries
with the ( + ) and ( - ) markings inside the
battery compartment during installation.
Install two AAA alkaline
batteries as shown here
Press arrow gently &
pull down to remove cover
Programming your remote control
Setup for your cable box
No setup is required. The remote control is
preprogrammed to operate your cable box.
Setup for your TV
Find your TV brand and its three-digit
code on the back of this manual. If the
TV brand is not listed, please use the
Searching Method in STEP3 .
STEP1 Turn on your TV manually.
*Tip : If you have RCA TV, don't turn
on the TV.
STEP2 Press [TV POWER] and [MUTE]
buttons simultaneously until the
red light is on.
STEP3 Point the remote control toward
the TV and enter the three-digit
code from the code table. If
there is more than one code
number assigned to your TV
brand, try one code number at a
time until the TV turns off right
after you entered the number.
Searching Method
Press [CH +] button and hold until the
TV turns off. As soon as the TV turns
off, release [CH+] button.
*Tip : You can confirm the power off and
on by pressing [MUTE] button.
STEP4 Press [TV POWER] button to
store the three-digit code.
*Tip: Red light will blink twice.
Three-digit code :
Set-up for your VOLUME control
The remote control is preprogrammed to
control VOLUME and MUTE functions
through your TV. To switch VOLUME and
MUTE functions to your Cable Box:
STEP1 Press [ ] and [MUTE]
buttons simultaneously until
red light is on.
STEP2 Press [VOLUME +] button.
STEP3 Press [ ] button.
To return to the TV's VOLUME, press
[TV POWER] button.
*Tip: Red light will blink twice.
Set-up for advanced functions
A. To turn on your TV and Cable at the
same time with button:
STEP1 Press [ ] and [0] buttons
simultaneously until the red
light is on.
STEP2 Press [CH +] button.
*Tip: Red light will blink twice
The [ ] button sends out the TV
and CABLE power commands if you
press the [ ] button.
To return to the original function, press
the [CH-] button in the STEP2 .
B. Recalling the TV Three-digit code :
STEP1 Press [TV POWER] and [MUTE]
buttons simultaneously until the
red light is on.
STEP2 Press [VOLUME-] button.
The red light will blink a number of
times indicating the number of each
digit of the code. Each digit is
separated by one second interval of
red light being off.
*Tip: One blink, three blinks and 10
blinks, indicates the code
number 130.
Helpful hints
Set-up for your Cable Box
The remote control is preprogrammed
to control your cable box. If it does
not work properly, please set-up the
right code by using the three-digit
code or searching method.
If you have a TV with a remote
control, we recommend that you plug
its power cord directly into a wall
outlet if available (your cable installer
may select an alternate setup)
Operation
If red light does not blink when
you press keys the operation is
intermittent:
Make sure the batteries are inserted
correctly.
Replace old batteries with two new
AAA batteries. Please do not mix old
batteries with new ones.