HELIX DSP.3 Manual page 18

Initial start-up and functions
- right position: input
8 Control pushbutton
for sound setups. The Control pushbutton allows
the user to switch between two memory positions.
Note: The memory locations one and two are de-
To manually switch between the setups the button
has to be pressed and held for one second. Switch-
LED. To switch between all internal memory loca-
remote control or the HELIX WIFI CONTROL is
recommended.
erases the internal memory. This is indicated by a
of the Status LED.
Attention: After erasing the setups from memo-
ry the HELIX DSP.3 will not reproduce any audio
output.
9 Status LED
The Status LED indicates the operating mode of the
signal processor and of its memory.
Green: DSP is ready for operation.
Orange:
Red:
ferent root causes. The HELIX DSP.3 is equipped
connecting failures such as short-circuits or other
wrong connections.
Red / green
installed. Connect the signal processor to the
Red / green
Sound Setup memory is empty. A new setup has to
18
and output ground
Connect your personal computer to the DSP.3
downloaded from the Audiotec Fischer website
Please note: It is not possible to connect any USB
This multi-functional input is designed for HELIX
DSP.3 accessory products like a remote control
Status
processor. Depending on the type of remote con-
software.
sors Power Input
amps by a signal from the ignition switch of your
inputs as desired using the DSP PC-Tool software.
-
-
No operating software
-
The currently selected
USB input
10
Control Input
11
Line Output
12
.
-
-