Yamaha Clavinova CLP-955 Service Manual page 16

CLP-955
SP Connector assembly
24. PEDAL Assembly
24-1 Remove the four (4) screws marked [4] at the bottom
of the keybed board and the pedal box assembly with
pedal pillars. (Fig. 16)
(Note)
The PK connector assembly wire is still connected to the
main unit, so take care not to damage the bundle wire.
24-2 Remove the bundle wire from the main unit. (Fig. 16)
24-3 Lay a soft cloth over the floor. Place the removed unit
on it carefully so as not to damage it. Use enough care
not to get hurt in this procedure.
24-4 Remove the eight (8) screws marked [40]. The pedal
assembly can then be removed. (Fig. 17)
16
A Pattern
[89] Partition board assembly
[89]: Truss Head Tapping Screw 4.0 × 18 MFZN2BL (V6696000)
(Fig. 15)
[4] × 4
PEDAL BOX assembly
[4]: Cup Screw 5.0 × 20 MFZN2BL (VD614900)
[40]: Bind Head Tapping Screw-B 4.0 × 12 MFZN2Y (VA914400)
B Pattern
[89]
SP Connector assembly
PK connector assembly
(Fig. 16)
PEDAL assembly
[40] × 8
(Fig. 17)