Yamaha Clavinova CLP-955 Service Manual page 15

20. BLOCK TOP
20-1 Remove the speaker grille assembly and the top board
(small) assembly. (See Procedure 1.)
20-2 Remove the key cover assembly. (See Procedure 7.)
20-3 Remove the panel assembly. (See Procedure 8.)
20-4 Remove the end block assembly (L, R). (See Procedure 12.)
20-5 Remove the key board unit. (See Procedure 16.)
¡Top View
[89] × 8
21. BAFFLE BOARD Assembly
21-1 Remove the speaker grille assembly and the top board
(small) assembly. (See Procedure 1.)
21-2 Remove the key cover assembly. (See Procedure 7.)
21-3 Remove the panel assembly. (See Procedure 8.)
21-4 Remove the end block assembly (L, R). (See Procedure 12.)
21-5 Remove the keyboard unit. (See Procedure 16.)
21-7 Remove the front rail assembly. (See Procedure 17.)
21-8 Remove the side cover assembly. (See Procedure 19.)
21-9 Remove the block top. (See Procedure 20.)
21-10 Remove the nine (9) screws marked [B] and the two
(2) screws marked [89]. The baffle board assembly
can then be removed. (Fig. 14)
[81]: Truss Head Tapping Screw-1 3.5 × 12 MFZN2BL (VV452700)
[89]: Truss Head Tapping Screw 4.0 × 18 MFZN2BL (V6696000)
Partition board assembly
[B] × 9
[89]
[89]: Truss Head Tapping Screw 4.0 × 18 MFZN2BL (V6696000)
20-6 Remove the front rail assembly. (See Procedure 17.)
20-7 Remove the side cover assembly. (See Procedure 19.)
20-8 Remove the eight (8) screws marked [81] and the eight
(8) screws marked [89]. The block top can then be
removed. (Fig. 13)
¡Bottom View
Block top board
A
(Fig. 13)
* The baffle board assembly can be removed if the
partition board is of the A pattern. But if it is of the B
pattern, if cannot be removed without removing the
wiring for the speaker because of the speaker's bundle
wire passing in the middle. (Fig. 15)
Baffle board assembly
(Fig. 14)
CLP-955
[81] × 8
A
A
A
15