Uniden BC780XLT Operating Manual page 51

To enter an EDACS
a. Enter ID you want to store.
Use the
b. Press E .
Hint: Remember that Uniden's AFS format allows you to enter full or partial EDACS IDs for
powerful flexibility in all modes. Be sure to read the section "EDACS Reception" on
page 49 to learn how this works.
Note: The BC780XLT defaults to "AFS" talkgroup displays for EDACS
––– OR –––
To enter a LTR ID:
a. Enter Area code and then press
b. Enter Home Repeater number and then press
c. Enter ID you want to store and then press E .
Note: To clear a mistake while entering an ID, press
start over.
4. Press MAN or HOLD/ L to select the next Scan List location.
Program ID Manually with the Menu Mode
Note: It is also possible to do ID programming in the menu mode by selecting TRUNK DATA
- BANK NO. - PROGRAM ID. Do the following:
1. Press MENU .
2. Press L or M to select TRUNK DATA and then
press E .
3. Press L or M to select the bank no. and then press E .
4. Press L or M to select the PROGRAM ID and then
press E .
Remember! You can also use the VFO control for scrolling. Also instead of pressing
E , you can press the VFO/SELECT control or press the SELECT/MUTE key.
5. Select the ID location using the VFO control, keypad,
L or M and then press E . (first number represents
the bank number and second number represents the
memory location.)(Direct entry method example: enter
"5-1" by pressing 5 ,
6. Press L or M to select ID and then press E .
7. Enter the ID number using the keypad and then press E .
Note: After you have programmed the ID in a selected bank while still in the menu mode,
you can set your alpha tag (see page 21), flag the individual ID or talkgroup for
recording (see page 32 and 11), or turn on the beep alert for an individual talkgroup
(see page 22).
® ID:
for the "dash".
, 1 .)
.
.
and E successively, and
43
® only.