Uniden BC780XLT Operating Manual page 80

If you experience difficulty while in TrunkTracker mode, try the following steps.
Problem
Scanner won't track.
Scanner won't stop
during Scan List mode.
Scanner will not acquire
data channel.
Missing replies
to conversations.
Channel Activity
Indicators are flashing
but no sound is heard.
Scanner not tracking
an EDACS system
properly.
If you still cannot get satisfactory results while using your scanner or if you want additional
information, please call or write the Uniden Parts and Service Division. The address and
phone number are listed in the Warranty at the end of this manual. If you would like
immediate assistance, please call Customer Service at (800)297-1023.
If you have internet access, you can visit www.uniden.com or www.trunktracker.com or
www.bearcat1.com/free.htm or www.bc780xlt.com for additional information.
1. May not be a system which can be tracked by
your scanner. Make sure you press and hold TRUNK
for 2 seconds to enter into trunk mode.
2. Missing the data frequency.
3. Change to a Type 1 Scanner setup.
Review Fleet Map Programming on page 54.
1. No IDs have been programmed.
2. The IDs you have stored are not active.
1. Adjust the squelch for trunking mode.
See page 39.
2. Missing the frequency used for the data channel.
Check your frequency list.
1. Change to a Type 1 Scanner setup.
Review Fleet Map Programming on page 54.
2. Try another Preset Fleet Map or Program your own
Fleet Map.
3. Check to see that all of the systems frequencies
have been entered.
1. May be a telephone interconnect call, which are
intentionally blocked by your scanner.
2. The ID in your display is not active.
1. Logical channel numbers (frequencies) for the system
are not programmed in the correct order.
Check frequency resources and reprogram.
2. Not all frequencies for the system are programmed.
Check frequency resources.
72
Suggestion