Table of Contents
Advertisement
Programming FIPS Code
The 6-digit Federal Information Processing System (FIPS) codes established by the National
Weather Service (NWS) must be programmed in your scanner. These codes specify an
emergency and the specific geographic area (such as county) affected by the emergency.
1. At the WX hold mode, press and hold WX for 2 seconds.
2. Select the desired memory number (F1-F15)
using L or M.
3. Enter FIPS code using the keypad.
4. Press E .
5. To exit from this programming mode, press WX .
––– OR –––
1. Press M when F1 is displayed or L when F15 is displayed.
2. Press E . The scanner is now set for ALL FIPS mode.
3. To cancel this ALL FIPS mode, enter individual
FIPS code again.
Note: • To cancel the entry, press
• To obtain the FIPS code for your area, contact the NWS toll free
at 1-888-697-7263.(1-888-NWR-SAME) or visit their website
http://www.nws.noaa.gov/nwr/indexnw.htm
.
35
Hide quick links:
Advertisement
Table of Contents
