Connecting The Base And Charging The Handset; Installing The Belt Clip - Uniden WDSS 5315 Owner's Manual

Connecting the Base and Charging the Handset

) Connect the AC adapter to the DC IN 9V jack.
CAUTION: To avoid risk of fire and shock, only use the Uniden
AAD-04S AC adapter.
2) Connect the AC adapter to a standard 240V AC wall outlet.
DO NOT use an AC outlet controlled by a wall switch.
3) Place the handset in the base with the LCD screen facing forward.
4) Make sure that the charge LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in and the
handset makes good contact with the charging contacts.
5) Charge your handset at least 5 to 20 hours before plugging into
the phone line.

Installing the Belt Clip

Line up the holes on each side of the handset. To attach the belt clip, insert into
the holes on each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the tabs from
the holes.
To AC outlet To AC outlet
AC adapter (supplied) AC adapter (supplied)
6
To DC IN 9V To DC IN 9V