Ups Trouble Connections; Connecting Nac And Power Outputs; Connecting To The Slc; External Coding And Synchronization - Honeywell Notifier ACPS-610/E Manual

Installation

2.5 UPS Trouble Connections

When a UPS is required, use a monitor module with a trouble Type ID to convey a trouble signal to
the FACP.
To normally
closed UPS
AC loss
contacts.

2.6 Connecting NAC and Power Outputs

TB3, TB4, TB5, TB6 - Outputs 1 through 4. Power-limited. Supervised when in NAC
configuration. Combined output provides up to 6.0 A total (or up to 10.0 A total with charger
disabled). All the outputs are independently configurable as NAC (constant, coded, or
syncronized) or Power (resettable, door holder, or general purpose). Each output provides 1.5 A
maximum current when configured as a NAC, 1.5 A maximum current when configured as Power
with the charger enabled, and 2.5 A maximum current when configured as Power with the charger
disabled. With all power sources off, connect wiring. Refer to Section 4 of this manual for
applications suggestions.

2.7 Connecting to the SLC

TB2 - Supervised and power-limited. With all power sources off, connect the power supply from
TB2 to the SLC interface.
Refer to the SLC Wiring Manual for more information.
acps-610_TB2-SLC.cdr

2.8 External Coding and Synchronization

Power-limited and non-supervised. UZC input is used to sync or code outputs from an external
source. TB1 provides support for external coding sources such as UZC-256 (pulsed 24V) or coded
NAC output, or it can be an external sync input for strobe circuits. With all power sources off,
connect wiring. Refer to Section 4 of this manual for applications suggestions.
24
47K EOL
Resistor
ELR-47K
Figure 2.15 UPS Trouble Connections
SLC A
Optional 4-wire
–
Return Loop
+
Style 6 (Class A)
Figure 2.16 Connecting to the SLC Interface TB2
UPS Trouble Connections
SLC B
+ To SLC
Interface
–
ACPS-610/E Manual — P/N 53018:A1 07/31/2007
SLC to
panel or
next
device
SLC from
panel or
previous
device