Husqvarna T435 Workshop Manual page 25

5
Hook the throttle actuator rod E to the throttle, put
the spring back onto the throttle. Place the throttle
and the spring in the handle part as shown in
fi gure 36. Refi t the electrical cables H in the slot as
shown in fi gure 36.
6
Place the throttle as shown in fi gure 37. Put the
handle bar in the handle unit.
7
The handle part is fastened with the screws A, see
fi gure 39. Note! Hold the throttle lockout down so
that the spring doesn't jump out when the handle
part is assembled.
8
Refi t the guide F, see fi gure 39. Fasten the air fi lter
holder with the air fi lter, then fasten the air fi lter
cover. Make sure the lock is open when you push
the cover into place.
Fig 36
Fig 37
Fig 38
Fig 39
Safety equipment
25
English –