Troubleshooting - Uniden 7100A Operating Manual

REMOTE OPERATION
6 Stop playback and message recording.
7 Record a memo.
81 Change OGM1. After the DTAM beeps, begin your new OGM1.
When you finish, press 6. The DTAM beeps and replays.
82 Play OGM1. If no OGM1 is recorded, the DTAM announces "You
have no announcement one".
91 Change OGM2. After the DTAM beeps, begin your new OGM2.
When you finish, press 6. The DTAM beeps and replays.
92 Play OGM2. If no OGM2 is recorded, the DTAM announces "You
have no announcement two".
After you press 2 or 3 to play messages:
Press To
1 Replay the previous message
3 Skip to the next message
4 Replay the current message
5 Delete the current message
6 Stop message playback
36

TROUBLESHOOTING

IF your 7100A DTAM unit is not performing to your expectations,
please try these simple steps. If you are still unable to resolve the
problems, contact Uniden Customer Service for assistance.
PROBLEM
Answering system does not work
Answering System does not answers
after 3 rings.
Messages are incomplete.
No sound on the base unit speaker during • Adjust the volume control on the side of
call monitoring or message playback.
Cannot record outgoing message (OGM)
SUGGESTION
• Make sure the telephone line cord
is plugged in.
• Make sure that the AC Adaptor
is plugged in.
• Make sure the DTAM is turned on.
• There has been a power failure.
Disconnect the telephone line cord,
press the reset button and re-connect
the telephone line cord.
• The memory may be full. Delete some
or all of the saved messages.
• The incoming messages may be too long.
• The memory may be full. Delete some
or all of the saved messages.
the DTAM. Refer page 26
• The memory may be full. Delete some or
all of the saved messages.
Continued over....
37