Table of Contents
Advertisement
18
PREPARATION
SETTING THE DAY AND TIME
The DTAM records the day and time of the call with each phone message.
Follow these steps to set the current day and time.
NOTE: •
Adjust Volume Slider on the right side of the DTAM to the
desired listening level.
•
If you do not complete each step within 8 seconds, the
DTAM sounds four beeps, you must then start again from Step 1.
•
To avoid having to reset the time if AC power is lost, we
recommend you install a backup battery before you set the
day and time.
1. Hold down
.
time set
displays briefly then
(the day of the week) appears
on the display, the DTAM
announces "Sunday".
2. To change the day of the week, repeatedly press
move forward or
to move backward until the DTAM
announces the desired day of the week.
3. Press
The DTAM announces the preset hour.
time set
4. To change the hour, repeatedly press
forward or
to move backward to the desired hour.
5. Press
The DTAM announces the preset minute.
time set
6. To change the minutes, hold down
forward or
to move backward to the desired minute.
7. Press
to confirm the settings,
time set
The DTAM announces the day and time then beeps.
To check the current day/time at any time, press
(clock)
to
to move
to move
appears.
disappears.
time set
19
Advertisement
Table of Contents
