Preparation; Setting The Day And Time - Uniden 7000A Operating Manual

PREPARATION

SETTING THE DAY AND TIME

The DTAM records the day and time of the call with each phone message.
Follow these steps to set the current day and time.
NOTE: •
Adjust Volume Slider on the right side of the DTAM to the
desired listening level.
• If you do not complete each step within 8 seconds, the
DTAM sounds four beeps, you must then start again from Step 1.
• To avoid having to reset the time if AC power is lost, we
recommend you install a backup battery before you set the
day and time.
1. Press and hold down
button until the DTAM announces
the day of the week.
Release the
2. Press
the DTAM announces the desired
day of the week.
3. Press
time set
4. Press
hour.
5. Press
time set
6. Hold down
desired minute.
7. Press
time set
The DTAM announces the day and time then beeps.
To check the current day/time at any time, press
time set
button.
time set
or until
The DTAM announces the preset hour.
or until the DTAM announces the desired
The DTAM announces the preset minute.
or
to confirm the settings,
until the DTAM announces the
19
appears.
disappears.
time set