Setting The Serial Port Speed; Displaying Scanner Information; Viewing Memory Used; Setting The Beartracker Options - Uniden BCT15 Owner's Manual

Setting the Serial Port Speed

Use this setting to control the data rate used for the front and back panel serial
ports. You typically set the front port to match the speed used to communicate with
your PC (default 115200 bps) and the back port to the speed used to communicate
with an attached GPS device (default 4800 bps). Note that the back port is male.
You may need a gender changer and a null modem adapter to use a typical DB9
serial cable from the rear port.
[MENU]
Settings
Set Serial Port
Set Baud Rate
Set Front Port or Set Rear Port
For Serial Port Speed (Baud Rate), you may select from
4800 bps
9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
Off

Displaying Scanner Information

Viewing Memory Used

[MENU]
Settings
See Scanner Info
% Memory Used
The scanner displays the percent of memory that is used, as well as the number
and percent of systems, sites, and channels that are created. Press any key to
return to the previous menu.

Setting the BearTracker Options

Set Hold Time

This is the time that the scanner remains on a transmission while scanning a
BearTracker system until it begins to scan a new system.
F
F
F
F
F
F
F
Programming General Settings
67