Fire Tone-Out Introduction; Setting Tone-Out Standby; Setting Up Tone-Out - Uniden BCT15 Owner's Manual

Your scanner can be set to respond to fire tone-outs, a system comprised of
standardized two-tone sequential paging, short one-tone paging, and long group
tone paging. You can save up to 10 settings. When you select a setting in standby
mode, the scanner also monitors for any other setting that uses the same transmit
frequency, modulation, and attenuation settings. To quickly switch to Fire Tone-Out
F
mode, press and then press [SQ].
You need tone-out setup information from the agency you wish to monitor. Check
with your local agency or on-line resources as Uniden America Corporation has no
information regarding local tone-out systems.

Setting Tone-Out Standby

[MENU]
Tone-Out for...
Tone-Out Standby
Turn the Scroll Control
tone-outs that have the same frequency, modulation, and attenuation setting as
the one you select, are also monitored.
In standby mode, the display cycles through all monitored tone-out settings.
Regardless of the current display, the scanner always alerts on any received
tone-out that matches a stored setting.
If you press [HOLD/RESUME] while in standby mode, the scanner temporarily
exits the mode and you hear all transmissions on that frequency. No alerts sound,
even if a tone-out matches one you have stored. Press [HOLD/RESUME] again to
return to standby mode.

Setting Up Tone-Out

[MENU]
Tone-Out for...
Tone-Out Setup
Scroll to select the tone-out (1 - 10) you want to program, then press
can scroll to any of the following settings and press
selected settings:
Edit Name — Sets the name for the selected tone-out setting.
Set Frequency — Sets the tone-out's RF frequency parameters. Then select:
Edit Frequency — Enter the desired frequency that the scanner should monitor
for the tone-out.

Fire Tone-Out Introduction

F
to select which of the ten tone-outs to monitor. All
F
F
F
F
to select and modify the
Fire Tone-Out Introduction
F
.
Then you
123