Installing The Belt Clip; Connecting The Base And Charging The Handset - Uniden WDSS 5355 Series Owner's Manual

Installing the Belt Clip

Line up the holes on each side of the handset. To attach the belt clip, insert into
the holes on each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the tabs from
the holes.

Connecting the Base and Charging the Handset

1) Connect the AC adapter (AAD-041S(M)) to the
jack.
2) Connect the AC adapter to a standard 240V AC wall outlet.
3) Place the handset in the base with the LCD screen facing
forward.
4) Make sure that the charge LED illuminates. If the LED
does not illuminate, check to see that the AC adapter is
plugged in and the handset makes good contact with the
charging contacts.
5) Charge your handset at least 15 to 20 hours before
plugging into the phone line.
DC IN 9V
Route the cord.
To AC outlet
Caution: To avoid risk of fire and shock, only
14
To DC IN 9V
AC adapter (supplied)
use the Uniden AAD-041S(M) adapter.