Chain Dialing; Memory Dialing (Base Only) - Uniden DCT 5285 Owner's Manual

• The 10 memory
locations in the base
are independent from
the handset.
• If you have not
pressed any key for
30 seconds, the
phone returns to the
standby mode.
• If you make or
receive a call, the
operation is canceled.
[ 44 ] P H O N E B O O K

Chain Dialing

The memory locations in the handset are not limited to phone numbers. You can also
store a group of numbers (up to 20 digits), that you need to enter once your call
connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Store a special number in the phonebook
location (refer to "Storing Phone Numbers, Names, Distinctive Rings and Speed Dial"
on page 37). Once you have called your bank, and when you are prompted to enter the
account number, just as you do when viewing the phonebook location, view the special
number, then press the DIAL soft key.

Memory Dialing (base only)

You can store 10 phone numbers in the base, and make calls with memory dialing
from the base.
Storing Phone Numbers
1) Press memory in the standby mode.
2) Enter the number you wish to store. (The number cannot exceed 20 digits.)
3) Press memory. Enter the memory location number (0-9) on the keypad.
You will hear a confirmation tone.
Making Calls with Memory Dialing
1) Press (talk) in the standby mode.
2) Press memory. Enter the memory location number (0-9) to dial the number.
Deleting the Stored Data
1) Press memory in the standby mode.
2) Press memory again.
3) Enter the memory location number (0-9) you wish to delete.
You will hear a confirmation tone.