Installing The Belt Clip; Connecting To The Phone Line; Testing The Connection - Uniden Cordless Telephone User Manual

Installing the Belt Clip
1) Line up the holes on each side of the handset. To attach the belt clip, insert into the holes on
each side of the handset. Press down until it clicks.
2) To remove the belt clip, pull either side of the belt clip to release the tabs from the holes.
Connecting to the Phone Line
Once the handset battery pack is fully charged, connect the
telephone line cord to the TEL LINE jack and to a telephone
outlet.
Testing the connection
(supplied)
To test your connection, try making a call. If your call connects, the settings are fine. If your call does not connect,
check the following:
1) Check the AC adapter cord. Make sure it is securely connected to the DC IN connector and to a standard AC
power outlet.
2) Check to make sure the battery is fully charged. (If you don't see the "battery full" icon, check to make sure
the battery is properly connected.)
3) Change dial mode (instructions on page 20).
19