Controller Id Number/Address - Emerson AXIMA 2000 Installation Manual

AXIMA 2000/4000 Installation Manual
Table 3
Max baud rate
Stop bit
Data bits
Parity
NOTE:

Controller ID Number/Address

The following table shows how the Address DIP switch positions
relate to the AXIMA 2000/4000 controller axis ID number. The DIP
switches are located behind the top front access panel of the AXIMA
2000/4000.
ACCESS PANEL
REMOVAL INSTRUCTIONS
THE ACCESS PANEL IS REMOVED
BY GRASPING THE PLASTIC PANEL
FIRMLY, PUSHING DOWN ON THE
TOP OF THE PANEL, AND PULLING
OUT WITH SLIGHT PRESSURE.
Figure 18 AXIMA 2000/4000 Address DIP Switch Location
26
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Serial Communications Setup
Serial Communication Setup
38.4 K
1
8
none
As baud rates increase or cable lengths get longer your
susceptibility to noise increases. Therefore, if you are
experiencing communication problems, it is
recommended that you install a ½ watt terminating
resister, 100 for RS422 and 120 for RS485.
ADDRESS
1 2 3 4
ON
OFF