Menu Configuration; Action Buttons; Menu Description; Battery Connection - GRAUPNER POLARON AC/DC SPORTS Operating Instructions Manual

◎ MENU CONFIGURATION

Graupner/SJ POLARON Series chargers are equipped with a highly sensitive touch screen.
Touch the icons to access every mode and set up your device.

ACTION BUTTONS

- INC button: Data setup
- LEFT button: Page transition
- ESC button: Return to the previous page, store the setup data, etc
- RIGHT button: Page transition
- DEC button: Data setup

MENU DESCRIPTION

Main page Function
PROFILE Battery name, type, capacity, number of cells, memory number, memory copy
CHARGE Setup the battery charge data
DISCHG Setup the battery discharge data
CYCLE
Setup cycle type and delay the time of charge / discharge( using the charge / discharge setup data )
BALANCE Display the cell voltage and related data. Setup the balance data
DATA Display the completed data and battery status
MISC Servo, Motor, Warmer data Setup
USER SET Setup input data, warning, date, time, user name and etc.

◎ BATTERY CONNECTION

POLARON AC/DC SPORTS chargers have two sets of outputs on the front of the charger. Channel 1 is
on the left. Channel 2 is on the right. Each channel has two 4mm banana sockets with a 7 cell balance
port and a temperature sensor input port. An appropriate charge lead must be selected to match the
specific connector on your battery. The charge leads must be connected to the 4mm output sockets on
the specific charger channel, with the positive (+) lead connected to the red socket and the negative
(-) lead connected to the black socket.
Only connect the battery to the charge lead AFTER the charge lead has been connected
to the charger, as the connectors on the charge lead could touch together and cause the
battery to short circuit.
During the charging of a Lithium pack, the balance lead MUST be connected to the charger. The
charger has a 'JST-EH' type balance port, but also comes with other balance adaptor boards.
To use an adaptor board, connect the supplied balance adaptor board lead to the charger. Then,
connect the board using the appropriate battery balance connector. This balancing connector is
essential. Without connecting the balancing connector to the balancing port on the charger (i.e., the
main battery power leads ONLY are connected to the output banana sockets), the charger will charge
or discharge the connected Lithium pack without balancing it. Balancing a Lithium pack is highly
recommended. As some cells may retain more
11
- START button: Go to the next page, Complete the data setup, Start / com
plete the operation, store the setup data, etc.