Table of Contents
Advertisement
OWNER'S GUIDE
Shock Sensor-
Shock Sensor Programming/ Adjustment
To enter shock sensor programming:
Press and hold the
The park lights will flash and the siren will three times.
While the park lights are "ON", strike the vehicle with the amount of force
wanted to trigger the alarm.
NOTE: The siren will chirp 3 times each time the system detects impact.
Adjusting the shock sensor:
Press and release
Press and release
NOTE: Be careful not to impact the vehicle in a area that may cause damage.
The most common location for testing and setting the shock sensor is
the vehicles A-pillar. The A-Pillar is the metal support that runs from the
roof of the vehicle to the hood area.
To exit and save shock sensor programming:
Press and hold the
will flash the number of times of the shock sensor impact level chosen.
Example: Level 5 = 5 Chirps/ 5 Park Light flashes
IMPORTANT SECURITY NOTES!
If the system has been triggered (shock sensor, door input..), the siren
will sound for approximately 60 seconds. Press and release the
the
button to silence the siren (the system will remain armed).
Press and hold the
lights will flash three times to indicate the system had been triggered.
Alarm series ONLY!
and the
buttons for three seconds.
to increase sensitivity (up to 10 chirps/ flashes).
to decrease sensitivity (down to 1 chirp/ flash).
and the
buttons, the siren will chirp and the park lights
button to disarm the system. The siren and park
PAGE 18
or
Advertisement
Table of Contents
