Adaptation To Wire Diameter - Lincoln Electric DIX WD 300 Safety Instruction For Use And Maintenance

8695 5601 / D

6 - ADAPTATION TO WIRE DIAMETER

Spring blade
Identification
The corresponding wire diameter is provided on the front of the drive rollers :
Replacing the wire drive rollers
- Open the wire feeder door.
- Clear the spring blade from the pressure screw and lift the compression clamp.
- Loosen the drive rollers with a 4-mm hex socket key, turning to the left.
- Remove the screws entirely, take out the rollers and replace with others.
- During assembly, fasten the screws with the key till the rollers turn as well.
TOPTIG
Inlet bush
Steel wire
Example : DIX DV – 04 – 12 / 12 T
Pressure screw
Compression clamp
Drive roller
Ø 1,2 mm
C - STARTING UP
Feed direction
C-7