Troubleshooting Guide - U-Line 1115R Use And Care Manual

Troubleshooting Guide

DANGER
ELECTROCUTION HAZARD
Never attempt to repair or perform maintenance on
the unit until the main electrical power has been
disconnected.
Troubleshooting - What to check when problems occur:
PROBLEM
Unit does not operate and
electronic display is blank.
No interior light
Light won't go out when door is
closed (Model 1175BEV).
Unit not cold enough
The unit frosts up.
Noise during operation
Unit too cold
Freezing product
POSSIBLE CAUSE
No electrical supply
Loose or burned out bulb
Light on/off switch is turned to ON.
Light staying on
Door gasket not sealing properly
Item(s) interfering with door
Dirty condenser coils
Airflow to front grille blocked
High ambient temperature or
exposure to direct sunlight
Temperature not set cold enough
Door gasket not sealing properly.
Door left open
High ambient temperatures or
humidity
Certain sounds are normal.
Fan blade touching obstruction
(wiring, foam insulation, etc.)
Temperature control set too cold
Product touching evaporator in back
of unit
1115R, 1175R, 29R, 1175BEV
NOTE: Recommended temperature setting is 38°.
REMEDY
Plug unit in or check circuit breaker.
Tighten or replace bulb (See MAINTENANCE; LIGHT
BULB REPLACEMENT).
Turn switch to OFF (See OPERATION).
Adjust door (See MAINTENANCE; DOOR ALIGNMENT
CHECK AND ADJUSTMENT).
Adjust door (See MAINTENANCE; DOOR ALIGNMENT
CHECK AND ADJUSTMENT).
Reposition or remove item(s).
Clean condenser (See MAINTENANCE; CONDENSER
CLEANING).
Airflow must not be obstructed to front grille (See
OPERATION).
Reposition unit.
Set control to a cooler setting (See OPERATION). Allow
24 hours for temperature to stabilize.
Adjust door (See MAINTENANCE; DOOR ALIGNMENT
CHECK AND ADJUSTMENT).
Defrost unit manually (See MAINTENANCE;
DEFROSTING).
Soft sounds from the fan and water/dropping sounds
from the ice maker will be heard.
Remove obstruction.
Set control to warmer setting (See OPERATION).
Move product away from evaporator, making sure it is
not touching evaporator.
25