U-Line 1115R Use And Care Manual page 17

Figure 24
5. Remove screws on opposite side of cabinet (Figure 24).
Note that there may be a nut behind one or both
screws on either side.
Figure 25
6. Install hinge on opposite side, bottom of cabinet
(Figure 25). Replace nut on back side where installed.
Align hinge outer edge with cabinet before tightening
screws.
1
Figure 26
ULIN_0122 _A
ULIN_0123 _A
ULIN_0109_A
1115R, 1175R, 29R, 1175BEV
7. Relocate plastic spacer/bushing (Figure 26) on bottom
of door to opposite side, and place door on bottom
hinge pin. Clean out bushing hole in door bottom with
a screwdriver if necessary.
Plastic
Plug Hole
Right Side
Door Swing
Right Side
Hinge
Figure 27
8. Remove plastic hole plug (Figure 27) from door handle
and relocate on opposite side.
9. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge. See Figure 30.
Figure 28
10. Remove three plastic screw plugs (Figure 28) from
hinge holes, top of cabinet, opposite side. Be careful
not to scratch cabinet.
11. Place door on lower hinge pin. Invert and install upper
hinge on door.
Figure 29
Hinge
Plastic
Plug Hole
Screw
Left Side
Door Swing
Invert Invert
Screw Hinge
ULIN_0142_A
ULIN_0144_A
ULIN_0145_A
17