MARINE SERIES
Door Alignment Check and
Adjustment
IMPORTANT
IMPORTANT
Properly aligned, the door's gasket should be firmly
in contact with the cabinet all the way around the
door (no gaps). Carefully examine the door's gasket
to assure that it is firmly in contact with the
cabinet. Also make sure the door gasket is not
pinched on the hinge side of the door.
Hinge screws
Figure 14
1. Loosen (do not remove) top (Figure 14) and bottom
hinge screws.
2. Align door squarely with cabinet.
3. Make sure gasket is firmly in contact with cabinet all
the way around the door (no gaps).
4. Tighten bottom hinge screws.
5. Tighten top hinge screws.
Door Reversal
Depending upon the location of the unit, it may be
desirable to change the side on which the door is
mounted.
To reverse the door mounting, perform the following:
Model
SS1095FC
Figure 15
ULIN_1044_A
Model
SS1095FD
Grille
screw
ULIN_1038_A
1. Remove grille (one screw) (Figure 15).
2. Remove top hinge from cabinet (three screws) (Figure
14). Hold door to keep it from falling.
3. Lift the door off the bottom hinge.
4. Remove bottom hinge from cabinet (two screws)
(Figure 16).
5. Remove screws on opposite side of cabinet (Figure 17).
SS1095
Figure 16
ULIN_0122 _A
Figure 17
11