Table of Contents
Advertisement
USER GUIDE
Door Adjustments
DOOR ALIGNMENT AND ADJUSTMENT
Align and adjust the door if it is not level or is not sealing
properly. If the door is not sealed, the unit may not cool
properly, or excessive frost may form in the interior.
NOTICE
Properly aligned, the door's gasket should be
firmly in contact with the cabinet all the way
around the door (no gaps). Carefully examine the
door's gasket to ensure that it is firmly in contact
with the cabinet. Also make sure the door gasket
is not pinched on the hinge side of the door.
To align and adjust the door:
1.
Loosen (do not remove) top and bottom hinge screws
using a Torx T-25 screwdriver on the top and a 1/4"
socket on the bottom.
2.
Align door squarely with cabinet.
3.
Make sure gasket is firmly in contact with cabinet all
the way around the door (no gaps).
4.
Tighten bottom hinge screws.
5.
Tighten top hinge screws.
REVERSING THE DOOR
Location of the unit may make it desirable to mount the
door on the opposite side of the cabinet.
The hinge hardware will be removed and reinstalled on the
opposite side of the cabinet.
Remove arrow clips:
1.
With a puddy knife or other flat tool, gently pry each
arrow clip from hinge mounting holes.
2.
Set aside arrow clips to be reused on the opposite
side.
Door Adjustments
Arrow Clip
TO REVERSE THE DOOR
Remove top hinge and door:
1.
Hold door to keep it from falling.
2.
Remove top hinge from cabinet using a Torx T-25
screwdriver to remove three screws.
Hinge screws
3.
Remove door by tilting forward and lifting door off
bottom hinge. Retain shoulder washers; they will be
reused.
4.
Remove three screws from hinge holes on the opposite
side (stainless steel model only).
5.
For stainless steel model, install three screws into
holes where the hinge was removed; black or white
models, install 3 arrow clips.
Move bottom hinge:
1.
Remove bottom hinge from cabinet using a 1/4"
socket.
Note: If unit is equipped with a plastic grille,
remove the top center screw and the bottom
screw on the hinge first. Remove grille and other
hinge screw, and proceed to Step 2.
Center Screw
13
Remove two
hinge screws
Advertisement
Table of Contents
Troubleshooting
