Table of Contents
Advertisement
Chapter 2
Board Installation
should use is located at the top-center of the board where the adapter cards
are fastened to the case.
Plug in the power connector as shown.
The photos below show the ATX power connector before (Figure 1) and after
(Figure 2) it has been plugged in.
The plastic clip on the power connector should lock over the plastic tab on the
onboard connector. You shouldn't be able to plug the power connector in any
other way but just to be safe, make sure it looks like Figure 2 above. Make
certain that you do not miss any pins because, if you do, you will void your
warning
warranty and cause damage to yourself or your motherboard when you turn
the system on. After connecting the power, make sure the connector is seated
firmly into its socket so it will not become loose or fall off when the computer
is jostled or moved. Note: Tyan recommends using an ATX power supply that
conforms to industry standard revision 2.01.
Figure 1
Figure 2
12
http://www.tyan.com
Advertisement
Table of Contents
